What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 09:01

2024–10–10[John johnson John Johnson ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
What Happened at Pitchfork’s Zine Launch With Turnstile - Pitchfork
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
eight
The bolt then partially travels down the line to your home.
What are some ways to cope with paranoid thoughts about being gangstalked or targeted individuals?
but this device (an Inductor) … impedes the rapid changes in the current.
but I think this circuit , shows a few more pieces.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Report: Steelers expect to have a deal with T.J. Watt by the start of the season - NBC Sports
What does a fuse do?
He then describes the function of a fuse.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What is one small habit that has transformed your life in unexpected ways?
so, what happens?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The MOV will conduct when the voltage exceeds 50% of line voltage.
For this case there are devices called Metal oxide varistors (MOV).
First Sentence:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
How many trans people are lawful gun owners?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Here is a simplified AC power diagram.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
How many women have accidentally pooped their pants and became turned on afterwards?
There are two important concepts here.
[old diagram got deleted by accident]
nine
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This one hit behind the barn.
I post the exact comment here.
It also is a device that limits the change in current flow.
Barnstars:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
New Study Finds 1 Promising Way To Keep Colon Cancer From Returning - HuffPost
One
This device then solves the entire problem.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
These devices are installed between the “hot” and “neutral” and protective ground.
A fuse is a non-resetable over current circuit protector.
One is “what exactly is in a ‘surge protector’ ? ”
the problem then depends on "how fast does the fuse operate?".
In schematic diagrams this is the symbol for a fuse:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
[image of Common-mode choke]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then asserts :
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
What is lightning?
This is where the MOV conducts again, and dissipated the energy.
Because the load is inductive, the current lags the voltage.(by a bit).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A circuit breaker is similar, but is resettable.
Upvotes:
Now when you have a certain ac resistance, then a current flows in a loop.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The other is “what does a “fuse” do?”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But… the neutral is now “floating” because of the 1 ohm resistance.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
These are simplified answers to the original question, and does not change anything I wrote above.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At one ohm, the resistor has a maximum of 1 watt power.
what exactly is a ‘surge’ protector?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It seems Mohan does not understand the difference between a comment and an Answer.
He then describes Rainy Season and Lightning.
This is 'the assistant's answer'
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At least they know the answer if they wanted it.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The third is lightning and “how it gets conducted into a home.”
Edit 2024–10.
a photo is worth a thousand words.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
(Dc diagram shown, AC is similar).
There are three different concepts here that are getting confused.
But it can get overloaded, and no longer works.